Hubsan Official Forum

Hi, I am in possession of your product the H501SS and I have updated the firmware as per your official website (H501SS Update 09-2018), following your guides everything is ok for FC-RX-TX. (attach the photos of the first firmware and after the firmware).
Later I tried to update the camera's firmware. I followed the instructions in the Camera-Board-Firmware-Installation-Instructions.docx file and in the https://youtu.be/MPb55C4f-js video. Everything seems to have been successful, but in the video is shown in the version of the radio remote control in addition to the firmware of the drone and radio control firmware CAM v30.84.84 (corresponding to the camera). I tried to verify it in mine, but this information (CAM v30.84.84) is not shown to me.
My questions are these:
1) Why does not I see CAM v30.84.84?
2) How can I verify which firmware I have in my camera?

Hi if you saw the video. He explains it about 7:18secs in. As far as I know You won't be able to see the firmware version at all. The one you have there according Chris Wade. He even says that the cam numbers you see there is not the firmware versions. Hope that helps a little bit.

I noticed the lower picture shows a H501S apparently after the update. The top picture shows a H501SS. Is this part of the problem? Did you use the wrong update?