Hubsan Official Forum

I upgraded my "low" edition H109S to the midrange edition by adding on the 3 axis gimbal. I noticed that the gimbal has a tiny connector on the output motor, near where the camera mounts onto the gimbal. The gimbal came with a mini-USB cable that plugs in to the output motor and plugs in to the Hubsan camera. The camera seems to get power when connected this way, but there is no USB signal unless you connect the camera to the external cable instead. Has anyone been successful in getting the camera to work using the gimbal's internal wiring instead of the clunky and bulky external cable?

Hello,

Would you mind to provide the picture to show how you connect the cable ?Just for better checking.thanks