Hi All,
Have a new H122D x4 new out of the box, and I can’t seem to arm the motors at all. All other setup seems to work fine, binding, calibration and video etc all lights seem fine other than a flashing blue LED which I’m not sure what it is..pulling both sticks down to the outside on the remote and doesn’t want to engage..have tried a few different ways to pull the sticks like down to the inside, up to the outside and inside etc..battery is fully charged..please help a noob if you have any insight or experience with this..many thanks.
H122D out of the box, motors won’t arm!!
-
- Posts: 1
- Joined: Wed Dec 30, 2020 4:03 pm
Re: H122D out of the box, motors won’t arm!!
Try calibrating the remote.
Re: H122D out of the box, motors won’t arm!!
Hi, thanks for responding.
I have tried recalibrating and it connects all fine and seems to run fine, still getting the same issue.
I have been told to try connecting beta flight..which I’m now downloading, not sure if it’s supported though.
Does anyone know how I might reset to factory settings or do some kind of flash on it at all?
I have tried recalibrating and it connects all fine and seems to run fine, still getting the same issue.
I have been told to try connecting beta flight..which I’m now downloading, not sure if it’s supported though.
Does anyone know how I might reset to factory settings or do some kind of flash on it at all?