Page 1 of 1
FIRMWARE ZINO PRO PLUS
Posted: Sun Feb 06, 2022 12:21 pm
by dimeglio
After firmware update of 27.09.2021, impossible to launch ZINO PRO PLUS
Drone angle too large Even after IMU calibration, still the same problem.
Came back old firmware.
Re: FIRMWARE ZINO PRO PLUS
Posted: Thu Feb 10, 2022 9:11 am
by me_1059c8nr3Y
I apologise if you have already done this but have you also done horizontal calibration on a level surface in the App? I have a different model to you and its not to hand but I'm sure I have separate horizontal and IMU calibration. My understand is IMU and gyro are two separate components.
I hope this helps.
Re: FIRMWARE ZINO PRO PLUS
Posted: Sun Feb 13, 2022 11:39 am
by dimeglio
Yes I did the calibration on a flat surface but it didn't work.
I will try to reinstall this firmware in the week after downloading it again.
Re: FIRMWARE ZINO PRO PLUS
Posted: Mon Feb 28, 2022 4:16 pm
by dimeglio
Managed to fly my ZINO PRO PLUS this weekend.
New firmware download and it works.
Surely a problem when decompressing the file.
Calibration IMU OK
Re: FIRMWARE ZINO PRO PLUS
Posted: Fri Feb 16, 2024 2:00 am
by me_0e1b4eneWd
can i ask download new firmware?
Re: FIRMWARE ZINO PRO PLUS
Posted: Sun Mar 03, 2024 4:49 am
by dimeglio
I kept the old firmware.