FIRMWARE ZINO PRO PLUS

Post Reply
dimeglio
Posts: 24
Joined: Thu Feb 11, 2021 1:34 pm

FIRMWARE ZINO PRO PLUS

Post by dimeglio » Sun Feb 06, 2022 12:21 pm

After firmware update of 27.09.2021, impossible to launch ZINO PRO PLUS :evil:
Drone angle too large Even after IMU calibration, still the same problem.
Came back old firmware.

me_1059c8nr3Y
Posts: 13
Joined: Tue Dec 28, 2021 3:17 pm

Re: FIRMWARE ZINO PRO PLUS

Post by me_1059c8nr3Y » Thu Feb 10, 2022 9:11 am

I apologise if you have already done this but have you also done horizontal calibration on a level surface in the App? I have a different model to you and its not to hand but I'm sure I have separate horizontal and IMU calibration. My understand is IMU and gyro are two separate components.
I hope this helps.

dimeglio
Posts: 24
Joined: Thu Feb 11, 2021 1:34 pm

Re: FIRMWARE ZINO PRO PLUS

Post by dimeglio » Sun Feb 13, 2022 11:39 am

Yes I did the calibration on a flat surface but it didn't work.
I will try to reinstall this firmware in the week after downloading it again.

dimeglio
Posts: 24
Joined: Thu Feb 11, 2021 1:34 pm

Re: FIRMWARE ZINO PRO PLUS

Post by dimeglio » Mon Feb 28, 2022 4:16 pm

Managed to fly my ZINO PRO PLUS this weekend.
New firmware download and it works.
Surely a problem when decompressing the file.
Calibration IMU OK

me_0e1b4eneWd
Posts: 3
Joined: Tue Jan 22, 2019 3:07 pm
Location: Indonesia
Contact:

Re: FIRMWARE ZINO PRO PLUS

Post by me_0e1b4eneWd » Fri Feb 16, 2024 2:00 am

can i ask download new firmware?

dimeglio
Posts: 24
Joined: Thu Feb 11, 2021 1:34 pm

Re: FIRMWARE ZINO PRO PLUS

Post by dimeglio » Sun Mar 03, 2024 4:49 am

I kept the old firmware.

Post Reply