Hubsan Official Forum

Like an idiot I received my Zino 2+, unboxed it, calibrated it and was almost ready to fly when I clicked the firmware upgrade button. Long story short, the upgrade failed at 75%. Now I am forced to upgrade via USB. The problem I have encountered now is that the video upgrade button will not depress and power up the drone. What the hell???!!!

Has anyone else encountered this? Am I now forced to do a factory reset?

I'm also is upgrade failed at 83%.

Wow that sucks.

Unboxed mine upgrade required. No sd card msg.

Inserted good sd card upgrade 100%.

Sd card was a scan disk extreme pro 400gb.

Any progress for it problem?
I'm also is upgrade failed.

i have same problem with it

check this video

https://www.youtube.com/watch?v=xbvQc-jPK_w


I dont understand very hard for upgrade firmware, WTF.

& Slow respon support from hubsan, very very disappointed with this drone Zino 2 Plus

Same problem with ZINO 2+
First time I turn on App and connect Phone, I got message About firmware update. Than I Download firmware, plug in memory card (128gb U3) and Press update. Aupdate was in proces after few minutes nothing happening.. App got stuck.... Now the controler (transmiter) wont connect drone and Phone.. What to do now? Is there any help? O havent fly this new drone yet

Per the update instructions you can only use a newly formatted 32gb card. the instructions are in the firmware tutorial. Follow the instructions and you will have success

Card must be formated in FAT32 and not in extFAT ( usualy for card > 32GB).