Hubsan Official Forum

Posted: **Wed Nov 25, 2020 6:50 am**

Hi guys,
Just bought a new ZINO 2 and was forced to update the controller and Aircraft via APP. Controller seems ok but Aircraft update is stuck at 'send PW MD5 250..'.
I then tried via USB using Windows PC app and it looked ok at first but after that the App is still asking to update to latest firmware and therefore cannot use the drone at all.
Can you please advice or provide with a proper resolution? I tried any way possible to contact your support (email, call..) and no answer.
Thanks

Posted: **Wed Dec 02, 2020 9:04 am**

У меня такая же проблема , не могу использовать дрон без обновления, а обновление идёт бесконечно...если нашли решение, напишите, пожалуйста. Спасибо

Posted: **Mon Jan 04, 2021 7:09 am**

i have the same problem whit the update

Posted: **Mon Jan 04, 2021 7:12 am**

update will stop add 99%

Posted: **Sun Jan 17, 2021 8:04 am**

Was this fixed?

Posted: **Mon Jan 25, 2021 3:43 pm**

same problem except now my usb port pushed into the drone and broke off so I have to do it via app but won't work

Posted: **Mon Apr 26, 2021 9:04 pm**

I completed the update using a freshly formatted 32gb card. the instructions are in the firmware update tutorial. Follow it step by step and it will work...

Posted: **Tue Apr 27, 2021 5:16 am**

Do not forget, that card for flash must be in FAT32 and not in extFAT !

Hubsan Official Forum

ZINO 2 Aircraft 1.2.3 Aircraft update not working/Stuck

ZINO 2 Aircraft 1.2.3 Aircraft update not working/Stuck

Re: ZINO 2 Aircraft 1.2.3 Aircraft update not working/Stuck

Re: ZINO 2 Aircraft 1.2.3 Aircraft update not working/Stuck

Re: ZINO 2 Aircraft 1.2.3 Aircraft update not working/Stuck

Re: ZINO 2 Aircraft 1.2.3 Aircraft update not working/Stuck

Re: ZINO 2 Aircraft 1.2.3 Aircraft update not working/Stuck

Re: ZINO 2 Aircraft 1.2.3 Aircraft update not working/Stuck

Re: ZINO 2 Aircraft 1.2.3 Aircraft update not working/Stuck