Hubsan Official Forum

I lost my Zino.

Everything was going well.
Then I pressed the RTH button.
The Zino passed the point were it should land by 20 meters. Because of the wind??
Then is wend away with 70 km/h
I stopped the RTH and tried to return myself.
Well long story short the Zino was gone.
2 hours later the bell ring.
They brought back my drone.
Now when I start it I get no connection.
After a while the blue LED's from the drone flash 2 times.
I don't see any WiFi on the 5.4Ghz.
Also at the start up the camera is not moving at all.

Is there any solution?

Why is the Zino not turning after it passes the RTH point?

RTH is bugged.

I crashed my zino similiar way. Clicked rth button instead auto land. Did it twice cause i got confused why drone isnt auto landing but ascending and flying somewhere by itself (it was rth, but i didnt notice) so i pressed rth one more time (thinking its auto land). Then drone flew away itself into net and crashed. Lucky nothing broke. Be careful with rth

Hello me_6b2b5MFiPJ,

As your description of the Zino lost,will optimize the Zino wind resistance and auto land reminding.

I email you for further camera issue.