Hubsan Official Forum

• gimbal stabilization

Hi guy,
I need your help please. After a small crash to a tree, zino seemed to be fine, but was running low with battery, I decided to call it a day, and put it on the charger.
Yesterday with a fully caharged battery was flying again, but noticed the gimbal was not working, as the immage where very shaky.
Landed, restarted Zino, recalibrated gimabl, etc, but the image where still really shaky.
No visual damage on the drone or on the gimbal. Any ideas please what can I do?
Thank you for your advices guys!

Try the reset switch discussed previously as the gimbal controller may have gone out of spec. My Storm32 does this if you go over on to steep an angle all the time.

https://www.youtube.com/watch?v=yKQ2-3T3zkY

Hello Raptor79,

May I know if you update the Zino firmware to the latest one?

hi,not yet no.

Hello Raptor79,

Kindly update all firmware to the latest one then help us to check the gimbal image stabilization.

Firmware
https://www.hubsan.com/na/index.php?main_page=support
Tutorial video
https://www.youtube.com/watch?v=op73Bd0LNHg&t=2s

Hi,
Done. Downloaded the lastest firware, recalibrated everyhing I could remember, gimbal, compass, bounding, etc, everything before I was flying again today. Sadly the same result. . It flyes well, and picture is ok, but gimbal does not stabilaze the camera at all times. It is still very shaky. I have found a youtube video how to reset gimbal, but that video is not very well detailed, so I decided not to do anything. Can you please give me detalued istructions regarding the gimbal reset please?
Or do you have any another soultion?
Thank you for your advice!
Regards!