Page 1 of 1
updating zino
Posted: Thu Dec 13, 2018 11:08 am
by gherardo
Good day, I have updated the zino correctly following the tutorial but now I can not in any way to connect it to the command. Zino is not detected in any way impossible to connect it. I tried again to install updates but nothing. Before it worked regularly. What can I do?
Re: updating zino
Posted: Thu Dec 13, 2018 12:19 pm
by MrDronenut
I would guess you have "bricked "it.
Only solution............new quad
Re: updating zino
Posted: Thu Dec 13, 2018 12:58 pm
by ECA77
MrDronenut wrote: ↑Thu Dec 13, 2018 12:19 pm
I would guess you have "bricked "it.
Only solution............new quad
Great way to help him out.
I am sure the support can help you. It is rare to really "brick" something nowadays.
Re: updating zino
Posted: Thu Dec 13, 2018 9:17 pm
by Hubsan-Ailsa
Hello gherardo ,
May I know which firmware did you update?IT or FC or Gimbal firmware?
Re: updating zino
Posted: Mon Dec 17, 2018 7:19 pm
by me_e841aWTSUy
It sounds like we may have the same issue, but your description is a little vague
https://forum.hubsan.com/viewtopic.php?f=13&t=1243
gherardo wrote: ↑Thu Dec 13, 2018 11:08 am
Good day, I have updated the zino correctly following the tutorial but now I can not in any way to connect it to the command. Zino is not detected in any way impossible to connect it. I tried again to install updates but nothing. Before it worked regularly. What can I do?
Re: updating zino
Posted: Tue Dec 18, 2018 4:37 am
by Magnum1956PMQ
https://forum.hubsan.com/viewtopic.php?f=13&t=1232