Hubsan Official Forum

Same with my TX . My 5V charger (actually 5.3V) shows a charge current of .86 to .92A, but the battery is not charged.
2nd diode is blinking blue, but never gets solid blue.
So the TX battery is not charged. Its simply a faulty TX.

So I will send my Zino back to the Netherlands because the copter has the gim bal errror 0x0004 as well.....

Ah it charges!!! Think, my 5.3V power supply which is even capable of supplying 3A was the problem.

Maybe that the HT 016 just needs a slightly higher voltage for charging....
Gave it a second chance with my 2A Samsung cell phone charger and now the battery is charged. Second LED just became solid blue.

So I will wait a little before sending it to the Netherlands....

Hello, I also bought a Zino drones and I have the problem that this controller that blinks all 4LEDs flash slowly without stopping, even if I am also coupled with the application started. Thanks!

Hello me_a54afgA9wN ,

May I know if you full charged the HT016B?

Hello

I have tried in all possible ways with drone without drone, aplicaccion, if she, it does not work, does not start and stays with the LEDs flashing, the battery is fully charged

Hello after trying everything, there is no way and have the battery charged

two videos of the problem


https://www.youtube.com/watch?v=FXc2kXtcKiI

https://www.youtube.com/watch?v=mtgv9vDpnbY